Installing And Removing The Memory Modules; Installing & Removing Dimms - Supermicro X9DRW-3F User Manual

X9DRW-3F/X9DRW-iF Motherboard User's Manual
4. Once the heatsink is loosened, remove it from the motherboard.
Note: To reinstall the CPU and/or the heatsink, clean the surface of the
CPU and/or the heatsink to get rid of the old thermal grease. Reapply the
proper amount of thermal grease on the surface before reinstalling them
on the motherboard.
2-4

Installing and Removing the Memory Modules

Note: Check Supermicro's website for recommended memory modules.
Exercise extreme care when installing or removing DIMM
Installing & Removing DIMMs
1. Insert the desired number of DIMMs into the memory slots, starting with
P1-DIMMA1. (For best memory performance, please use the modules of the
same type and speed in the same bank.)
2. Push the release tabs outwards on both ends of the DIMM slot to unlock it.
UID
JUIDB
COM2
BMC
CTRL
JI2C1
JVRM_I2C1
JPG1
BIOS
JVRM_I2C2
JBT1 PCH
JBAT1
SATA/SCU4~7 SATA/ SCU0~3
JF1
JD1
1
JSM2 JSM1
FAN3
JL1
3. Align the DIMM module key with the receptive point on the memory slot.
4. Align the notches on the both ends of the module with the receptive points on
ends of the slot.
5. Use two thumbs together to press the notches of the module straight down
into the slot until the module snaps into place.
6. Press the release tabs to the locked positions to secure the DIMM module
into the slot.
modules to prevent any possible damage.
VGA COM1
USB0/1
LAN
CTRL
PHY
LAN2 LAN1
USB2/3 JPW4
IPMI-LAN
CPU2
CLOSE 1st
OPEN 1st
X9DRW-3F/iF
Rev.1.02
JPW3
CPU1
CLOSE 1st
SP1
JPW2
OPEN 1st
JVR1 FAN1
CAUTION
2-10
Notches
Release Tabs