Anchors; Latch-Type (Isofix) Child Seat Anchors - Mercedes-Benz CL Operator's Manual

Children in the vehicle
62
retractor ensures the seat belt will not
slacken once the child restraint system has
been secured.
Installing a child restraint system:
Always comply with the manufacturer's
X
installation instructions.
Pull the seat belt smoothly from the inertia
X
reel.
Engage the seat belt tongue in the belt
X
buckle.
Activating the special seat belt retractor:
Pull the seat belt out fully and let the inertia
X
reel retract it again.
While the seat belt is retracting, you should
hear a ratcheting sound. The special seat
belt retractor is enabled.
Push down on the child restraint system to
X
take up any slack.
Removing a child restraint system/
deactivating the special seat belt retractor:
Always comply with the manufacturer's
X
installation instructions.
Press the seat belt release button and
X
guide the belt tongue to the belt outlet.
The special seat belt retractor is
deactivated.
G WARNING
Never release the seat belt buckle while the
vehicle is in motion, since the special seat belt
retractor will be deactivated.

LATCH-type (ISOFIX) child seat anchors

in the rear
G
WARNING
Children that are too large for a child restraint
must travel in seats using normal seat belts.
Position shoulder belt across the chest and
shoulder, not face or neck.
A booster seat may be necessary to achieve
proper seat belt positioning for children over
41 lb (18 kg) until they reach a height where
a lap/shoulder belt fits properly without a
booster.
Install the child restraint system in
accordance with the manufacturer's
instructions.
Attach the child restraint system to both
securing rings.
An incorrectly installed child restraint system
could come loose during an accident and
seriously or even fatally injure the child.
Child restraint systems or child seat securing
rings that are malfunctioning or damaged as
the result of a collision must be replaced.
ISOFIX is a standardized securing system for
specially designed child restraint systems on
the rear seats. Securing rings for two LATCH-
type (ISOFIX) child restraint systems are
installed on the left and right of the rear seats.
Secure non-LATCH-type (ISOFIX) child
restraint systems using the vehicle's seat belt
system. Always install child restraint systems
according to the manufacturer's instructions.
Installation instructions : indicate the
installation location of securing rings 2.
Fold upholstery cover = and the Velcro
X
fastener upwards.
Turn installation aid ? to a vertical position
X
to prevent upholstery cover = from folding
down.
Install the LATCH-type (ISOFIX) child
X
restraint systems on both securing
rings ;. Comply with the manufacturer's