Mercedes-Benz CL Operator's Manual page 146

Navigation
144
In the address entry menu, confirm
X
by pressing W.
If no other route has been calculated, route
calculation starts immediately (Option 1). If
another route has already been calculated
(route guidance is active), a prompt
appears (option 2).
Option 1 – no route guidance active: route
calculation starts. While route calculation is
in progress, an arrow will indicate the
direction to your destination. Below this, you
will see a message, e.g.
being calculated.
Once the route has been calculated, route
guidance begins. If the vehicle is traveling on
a non-digitized road, the system displays the
linear distance to the destination, the
direction of the destination and the
Unknown message. In this case, the display
will be grayed out.
Option 2 – route guidance is already
active: if route guidance is already active, a
prompt will appear asking whether you wish
to terminate the currently active route
guidance.
Select Yes or
X
If you select Yes, COMAND will stop route
guidance and start route calculation for the
new destination.
If you select No, COMAND will continue
with the active route guidance.
i
Route calculation takes a certain amount
of time. The time depends on the distance
from the destination, for example.
COMAND calculates the route using the
digital map data.
The calculated route may differ from the
ideal route, e.g. due to roadwork or
incomplete map data. Please also refer to
the notes about the digital map
( page 176).
Y
Entering and saving your home address
You can either enter your home address for
the first time (option 1) or edit a previously
stored home address (option 2).
Fast route is
Street
No and press W to confirm.
Option 1: enter the address, e.g. a city,
Start
X
street and house number (
Once you have entered the address, select
X
Save in the address entry menu by turning
cVd and sliding ZVÆ the COMAND
controller and press W to confirm.
Select Save as "My Address"
X
W to confirm.
COMAND stores your home address as
Address
Option 2: proceed as described under
X
"Option 1".
A prompt appears asking whether the
current home address should be
overwritten.
Select Yes
X
After selecting Yes, the
successful
Entering a ZIP code
Entering a ZIP code will delete a previously
entered city.
Select Zip Code
X
by turning cVd and sliding ZVÆ the
COMAND controller and press W to
confirm.
You see the list of zip codes with the
character bar.
Enter a ZIP code. Instructions for entering
X
characters using city input as an example
can be found in the "Entering characters in
navigation mode (entering a city)" section
( page 122).
Y
page 141).
Y
in the destination memory.
and press W to confirm.
Save
message appears.
in the address entry menu
and press
My