Deactivating/Activating - Mercedes-Benz CL Operator's Manual

no engine-relevant diagnostics are active.
R
the driver's door is closed and the seat belt
R
is fastened.
Automatic engine start
The engine is started automatically if you:
release the brake pedal when HOLD is not
R
activated and the transmission is in
position D or N
shift the transmission to position R
R
depress the accelerator pedal
R
switch off the ECO start/stop function or
R
switch to drive program S or M
unfasten your seat belt or open the driver's
R
door
The engine is also started automatically if:
the vehicle starts to roll.
R
the brake system requires this.
R
the system detects moisture on the
R
windshield when the air-conditioning
system is switched on.
the temperature in the vehicle interior
R
deviates from the set range.
the charge level of the battery is too low.
R
Deactivating/activating the ECO start/
stop function
General notes
You can deactivate and activate the ECO
start/stop function using COMAND
( page 235).
Y
i
You can also use the programmable
button ( page 113) to activate and
Y
deactivate the ECO start/stop function if
you have assigned this function to the
button.
Deactivating
Deactivate the ECO start/stop function
X
using COMAND (
Y
The ¤ symbol goes out and the
Start deactivated
the multifunction display.
page 235).
Stop/
message is shown in
i
If drive program S or M has been selected,
the ECO start/stop function is always
deactivated.
Activating
Activate the ECO start/stop function using
X
COMAND ( page 235).
Y
The ¤ symbol and the
active message are shown in
multifunction display.
If not all conditions for automatic engine
switch-off ( page 276) are fulfilled, the
Y
Stop/Start inactive
i
If you activate the ECO Start/Stop
function in drive programs S or M, drive
program C is selected automatically.
Driving
277
Stop/Start
message appears.
Z