System Self-Test - Mercedes-Benz CL Operator's Manual

Cl class
Hide thumbs Also See for CL:
Table of Contents

Advertisement

If the SmartKey has been removed from the
ignition lock or is in position 0,
42 indicator lamp : does not
light up.
G
WARNING
If the red SRS 6 indicator lamp in the
instrument cluster and the 42
indicator lamp are lit at the same time, there
is a malfunction in the OCS. The front
passenger front air bag will be deactivated in
this case. Have the system checked by
qualified technicians as soon as possible.
Contact an authorized Mercedes-Benz
Center.
Only have the seat repaired or replaced at an
authorized Mercedes-Benz Center.
In order to ensure proper operation of the air
bag system and OCS:
Sit with the seat belt properly fastened in a
R
position that is as upright as possible with
your back against the seat backrest.
When seated, a passenger should not
R
position him/herself in such a way as to
cause the passenger's weight to be lifted
from the seat cushion as this may result in
the OCS being unable to correctly
approximate the passenger's weight
category.
Read and observe all warnings in this
R
chapter.
Occupant safety

System self-test

The 42 indicator lamp
illuminates when you:
turn the SmartKey to position 1 or 2 in the
R
ignition lock
press the KEYLESS-GO Start/Stop button
R
once or twice
If an adult occupant is sitting properly on the
front-passenger seat and the OCS classifies
the occupant as an adult, the
42 indicator lamp will illuminate
and go out again after approximately six
seconds.
If the seat is not occupied and the OCS
classifies the front passenger seat as being
unoccupied, the 42 indicator
lamp will illuminate and not go out.
G
WARNING
If the 4 2 indicator lamp does
not illuminate, the system is not functioning.
You must contact an authorized Mercedes-
Benz Center before seating any child on the
front passenger seat.
For more information, see "Problems with the
Occupant Classification System"
(
page 54).
Y
G
WARNING
Never place anything between seat cushion
and child seat (e.g. a pillow), since it reduces
the effectiveness of the OCS. The underside
and rear side child restraint system must be
placed entirely on the seat cushion and the
backrest of the front-passenger seat
backrest.
If necessary, adjust the tilt of the passenger
seat backrest.
An incorrectly mounted child seat could cause
injuries to the child in case of an accident,
instead of increasing protection for the child.
Follow the manufacturer's instructions for
installation of child restraint systems.
53
Z

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cl 550 4maticCl 600Cl 63 amgCl 65 amg

Table of Contents