Configuring Ethernet Communications On Older Ck31S - Intermec CK31 User Manual

Configuring Ethernet Communications on Older CK31s

CK31 Handheld Computer User's Manual
Note: The Ethernet option is no longer available on the CK31.
The information in this section is useful only if you already have
an installed base of older CK31s with the Ethernet option.
You can use an older CK31 directly in an Ethernet network if
you have ordered the Ethernet option on your CK31. Insert the
CK31 into an AD1 or AD2 Communications Dock. The
communications dock has an Ethernet connector that allows the
CK31 to communicate with your Ethernet network.
The CK31CN does not support Ethernet communications.
To use an older CK31 in an Ethernet network
1 Configure these network parameters on each CK31:
• If you have a DHCP server, enable DHCP.
• If you do not have a DHCP server, set these parameters:
a IP address
b Subnet mask
c Default router
2 If required for your network, you may also need to set these
parameters on each CK31:
• Primary and secondary DNS Servers
• Primary and secondary WINS Servers
3 Make sure that your CK31 is communicating with the
network and that the network can see your CK31.
Chapter 2 — Configuring the CK31
57