Intermec CK31 User Manual page 140

Problems While Scanning Bar Codes (continued)
Problem
Your 1551E or 1553 scanner
stopped working after you activated
energy saver mode or connected a
cable.
CK31 Handheld Computer User's Manual
Chapter 5 — Troubleshooting and Maintaining the CK31
Solution
You can enable energy saver mode only if the
scanner is connected to the CK31 by the energy
saver cable P/N 3-606032-03. Follow these steps:
1 Disconnect the scanner from the CK31.
2 Find the Reset Factory Defaults bar code in the
scanner documentation.
3 While pulling the trigger, hold the scanner over
the Reset Factory Defaults bar code, and apply
external power to the scanner. The scanner is
reset to factory defaults.
4 Use Intermec Settings to disable energy saver
mode on the CK31.
5 Use Intermec Settings to disable the port.
6 Attach the scanner to the CK31.
7 Use Intermec Settings to enable the port.
8 Use the scanner to scan a bar code. The scanner
should work now, but energy saver mode is
disabled. Continue with Steps 9 through 11
only if you want to use energy saver mode.
9 Install the P/N 3-606032-03 energy saver cable.
10 Use Intermec Settings to enable energy saver
mode on the CK31.
11 Use the scanner to scan a bar code. Energy saver
mode is enabled.
123