Ethernet Connection - Bosch DIVAR AN 3000 Manual

30 en | Hardware setup
Figure 5.2: Keyboard connector
Specifications
–
–
–
–
–
–
5.5

Ethernet connection

The standard RJ-45 Ethernet socket is used to connect the unit directly to a PC or to a
network. To connect directly to a network hub or switch, use a straight-through network
cable. To connect directly to a PC, use a cross-over network cable. Consult with your local IT
personnel for the specific type of cable needed. The maximum cable length from node to node
is limited to 100 meters (300 feet).
Specifications
–
–
–
2013.11 | 1.1 | AM18-Q0669
Keyboard cable connector
G
+ _
G G
power to
keyboard
RS-485 KEYBOARD
Communication protocol: RS485
Maximum signal voltage: ± 12 V
Power supply: 11 - 12.6 VDC, maximum 400 mA
Maximum cable length: 30 m (using standard 6-core telecom flat cable), or 1.5 km (using
Belden 8760 or equivalent in combination with the LTC 8557).
Cable type: black (cross-over) cable (supplied with keyboard)
Connector: RS485
1000 Base-T IEEE 802.3ab compliant, 100Base-TX IEEE 802.3u Compliant, 10Base-T IEEE
802.3 Compliant
IEEE 802.3 Compliant RGMII/MII
DSP processing
RJ11
_
+
+12V
+ _
G
G
keyboard
control
Operator Manual
DIVAR AN 3000 / DIVAR AN 5000
Bosch Security Systems