Ethernet Connection; En | Table Of Contents Divar An 3000 / Divar An - Bosch DIVAR AN 3000 Operation Manual

DIVAR AN 3000 / DIVAR AN 5000
3.
4.
Figure 5.2: Cable connections
5.5

Ethernet connection

The standard RJ-45 Ethernet socket is used to connect the unit directly to a PC or to a
network. To connect directly to a network hub or switch, use a straight-through network
cable. To connect directly to a PC, use a cross-over network cable. Consult with your local IT
personnel for the specific type of cable needed. The maximum cable length from node to node
is limited to 100 meters (300 feet).
Specifications
–
–
–
–
–
–
–
–
Bosch Security Systems
Attach the stripped wires to the keyboard connector on the back of the DVR according to
the following figure.
Insert the attached cable connector into the DVR connector on the back of the keyboard.
_
+
+12V G
KEYBOARD
1000 Base-T IEEE 802.3ab compliant, 100Base-TX IEEE 802.3u Compliant, 10Base-T IEEE
802.3 Compliant
IEEE 802.3 Compliant RGMII/MII
DSP processing
Transmission rate up to 1Gbps over industry standard CAT.5 UTP cable with BER less
than 10 in 1000Base-T
-10
Supports 3.3V or 2.5V signaling for RGMII
Supports power down mode and supports Link Down Power Saving
64-pin QFN or 100-pin LQFP
Connector: RJ45
G
_
+
+12V
Keyboard RJ11 cable (or equivalent)
DIVAR 5000
Operations Manual
Hardware setup | en
+12V
+
_
G
G
+ _
G
G
power to
keyboard
RS-485 KEYBOARD
2015.10 | v2.3 | AM18-Q0669
31
_
+
+12V
+ _
G
G
keyboard
control