Ptz; Sequence - Bosch DIVAR AN 3000 Manual

92 en | Operating instructions
–
7.2.2

PTZ

Figure 7.9: PTZ control
To swivel the camera view, click on any of the eight direction arrows on the left of the screen
Use this menu to also setup the following PTZ properties:
–
–
–
–
Click on icons
The other buttons on the bottom of the screen are used to assign and activate a set of
movements for the camera as follows:
1.
2.
3.
4.
5.
The Aux buttons are used when activating an ID for special processes stored in the camera
–
–
7.2.3

Sequence

Setup the camera sequence and interval times in the following configuration screens:
–
–
2013.11 | 1.1 | AM18-Q0669
Record, page 70
Speed: adjust the speed of the camera movements (value ranges from 1 to 8).
Zoom
Focus
Iris
and to increase or reduce the zoom, focus and iris
Enter a number (from 1 to 999) in the right field (this will be the ID for the preset PTZ
movements for the camera).
Use the eight direction arrows to swivel the camera to a desired position.
Click <Set> to assign the final position to the ID.
You will be asked to save the preset (use the focus
eventually added to the PTZ activation sequence if an alarm is detected – see Detect, page
57.
If required press <Shot> to move the camera immediately to a preset ID position.
Aux On: refer to your camera manual for the Aux definition.
Aux Off: switch off the special Aux definition
For monitor A - see Tour setup, page 64
For monitor B – see Sequence Mon B, page 79
Operator Manual
DIVAR AN 3000 / DIVAR AN 5000
button to save). This preset can be
Bosch Security Systems