Ethernet Connection - Bosch 670 Series Installation And Operation Manual

24 en | Hardware setup
4.5

Ethernet connection

The standard RJ-45 Ethernet socket is used to connect the unit directly to a PC or to a
network. To connect directly to a network hub or switch, use a straight-through network
cable. To connect directly to a PC, use a cross-over network cable. Consult with your local IT
personnel for the specific type of cable needed. The maximum cable length from node to node
is limited to 100 meters (300 feet).
Specifications
–
–
–
–
–
–
–
–
Figure 4.6 RJ-45 Ethernet connector
AM18-Q0617 | v2.0 | 2012.03
1000 Base-T IEEE 802.3ab compliant, 100Base-TX IEEE 802.3u Compliant, 10Base-T IEEE
802.3 Compliant
IEEE 802.3 Compliant RGMII/MII
DSP processing
Transmission rate up to 1Gbps over industry standard CAT.5 UTP cable with BER less
-10
than 10 in 1000Base-T
Supports 3.3V or 2.5V signaling for RGMII
Supports power down mode and supports Link Down Power Saving
64-pin QFN or 100-pin LQFP
Connector: RJ45
Installation and Operation manual
Video Recorder 670 Series
Bosch Security Systems