Table of Contents
Advertisement
Section 2: Getting started
Printer Installation
Before you begin:
Note:
12
Make sure that the external power supply is marked with the correct
mains voltage.
Attach the NPS 530/532 to your printer's parallel port and make a test
printout:
1. Switch off the printer.
2. Attach the NPS 530/532 to the printer, either directly to the parallel
printer port, or using the optional velcro ribbons and printer cable
extension.
3. Connect the external power supply. The PACKETindicator will flash
during power-on and self-test. When the indicator stops flashing and
remains unlit, the NPS 530/532 is ready for use.
4. Switch on the printer.
5. Press and hold the test button until the PACKET indicator starts to
flash, then release the button to print a test page.
The test page shows the software revision and the basic setup of your
NPS 530/532.
The NPS 530/532 supports high-speed Centronics communication such
as Hewlett-Packard Fast Mode. This function is disabled by default, since
some printers support standard Centronics only. To activate high-speed
Centronics, change the Output Menu parameter L1_CENTR to
HISPEED as outlined in Appendix A.
Axis NPS 530/532 User's Manual
Advertisement
Table of Contents
