68
Re m o vi n g a n d I n st a l l i n g Pa r ts
Computer Cover
•
Opening the computer cover
•
Closing the computer cover
Opening the Computer Cover
CAUTION:
Before you perform this procedure, see
For You and Your
NOTICE:
Before disconnecting a device from the computer, wait 10 to 20
seconds after disconnecting the computer from its electrical outlet. Before
removing a component from the system board, verify that the standby power
light on the system board has turned off. To locate this light, see
Components" or the interior service label.
Turn off the computer and devices, disconnect them from their
1
electrical outlets, and wait 10 to 20 seconds.
If you have installed a padlock through the padlock ring on the
2
panel, remove the padlock.
Lay the computer on its right side.
3
Open the computer cover:
4
Slide the cover release latch toward the top of the computer (see
a
the following figure).
Raise the back of the cover, and pivot it toward the front of the
b
computer.
Computer."
"Safety First—
"System Board
back