Dell Precision WorkStation 530 User Manual page 116

116 Re m o vi n g a n d I n st a l l i n g Pa r ts
Press the lever on the expansion card retention arm and raise the
4
retention arm (see
If necessary, disconnect any cables connected to the card.
5
Grasp the card by its top corners, and ease it out of its connector.
6
If you are removing the card permanently, install a filler bracket in the
7
empty card-slot opening.
If you need a filler bracket,
NOTE:
Installing filler brackets over empty card-slot openings is
necessary to maintain
also keep dust and dirt out of your computer.
Lower the expansion card retention arm and press it into place,
8
securing the expansion card(s) in the chassis.
Close the computer
9
Stand the computer upright.
10
Reconnect the computer and devices to their electrical outlets, and
11
turn them on.
NOTE: If enabled, the
message to be displayed at the next system start-up:
ALERT! Cover was previously removed.
If you removed a sound card, perform the following steps:
12
Enter system setup, select Integrated Devices and change the
a
setting for Sound to On.
Connect external audio devices to the audio connectors on the
b
computer back panel (see
If you removed an add-in network adapter, perform the following steps:
13
Enter system setup, select Integrated Devices and change the
a
setting for Network Interface Card to On.
Connect the network cable to the integrated connector on the
b
computer back panel (see
"Raising the Expansion Card Retention
contact Dell and order part number 81808.
FCC certification of the computer. The brackets
cover.
Chassis Intrusion
option will cause the following
"Back-Panel
"Back-Panel
Arm").
Features").
Features").