Vrm; Removing A Vrm - Dell Precision WorkStation 530 User Manual

126 Re m o vi n g a n d I n st a l l i n g Pa r ts

VRM

•

Removing a VRM

• Installing a VRM
NOTICE: A VRM must be installed for each
locate the VRM and microprocessor sockets, see
or the interior service label.
Removing a VRM
CAUTION: Before you perform this procedure, see
For You and Your
NOTICE: Before disconnecting a device from the computer, wait 10 to 20
seconds after disconnecting the computer from its electrical outlet. Before
removing a component from the system board, verify that the standby power
light on the system board has turned off. To locate this light, see
Components" or the interior service label.
Remove the airflow
1
Press the securing clips at each end of the socket outward
2
simultaneously until the module pops out slightly from the socket (see
the following figure).
Lift the module away from the socket.
3
microprocessor
Computer."
shroud.
installed. To
"System Board Components"
"Safety First—
"System Board