Dell Precision WorkStation 530 User Manual page 104

104 Re m o vi n g a n d I n st a l l i n g Pa r ts
If the drive bay was previously empty, remove the corresponding insert
14
from the front panel.
From inside the cover, press the ends of the insert outward with your
finger until the insert snaps free of the front panel.
NOTE:
If you are installing a hard drive, do not remove the drive bay
insert.
Close the computer
15
Stand the computer upright.
16
Reconnect the computer and devices to their electrical outlets, and
17
turn them on.
NOTE:
If enabled, the
message to be displayed at the next system start-up:
ALERT! Cover was previously removed.
Enter system setup
18
After you update the system settings, exit system setup and reboot the
computer.
Partition and logically format the drive before proceeding to the next
19
step.
See the operating system's documentation for instructions.
Run the Dell Diagnostics
20
If the hard drive you installed is the primary drive, install the operating
21
system on the drive.
See the operating system's documentation for instructions.
cover.
Chassis Intrusion
option will cause the following
and update your drive configuration information.
to test the drive.