Dell Precision WorkStation 530 User Manual page 125

For each of the replacement metal clips that secure the heat sink
c
to the microprocessor, fit the end of the clip that does not have the
latch to the heat sink retention base. Then, press down on the
clip's latch to secure the clip to the heat sink retention base (see
"Removing the Microprocessor Heat
Install the airflow shroud.
6
Close the computer
7
Stand the computer upright.
8
Reconnect the computer and devices to their electrical outlets, and
9
turn them on.
NOTE: If enabled, the
message to be displayed at the next system start-up:
ALERT! Cover was previously removed.
Enter system setup, and confirm that the top line in the System Data
10
area correctly identifies the new microprocessor. Also, confirm that the
values under the CPU Information menu are correct for the new
microprocessor.
Exit system setup, and then run the
11
new microprocessor is operating properly.
Sink").
cover.
Chassis Intrusion
option will cause the following
Dell Diagnostics to verify that the
Re movi ng and Inst alli ng Part s
125