Controls & Features - Troy-Bilt TB 27 LS Operator's Manual

Controls & Features
Cylinder
Tongue
Jack Stand
NOTE: This Operator's Manual covers several models. Log splitter
features may vary by model. Not all features in this manual are
applicable to all log splitter models and the log splitter depicted
may differ from yours.
Engine Controls
See the Engine Operator's Manual for the location and function
of the controls on the engine.
Beam Locks
These two locks, as their name suggests, are used to secure the
beam in the horizontal or the vertical position. The vertical beam
lock is located next to the engine. The horizontal beam lock is
located on the beam support latch bracket.
Control Handle
The control handle has three positions; Forward, Neutral and
Reverse. See the Operation section for instructions.
Control Handle
Log Dislodger
Figure 4-1
Wedge
The wedge is used to split the wood.
Log Dislodger
The log dislodger is designed to remove any partially split wood
from the wedge. This may occur while splitting large diameter
wood or freshly cut wood.
Log Tray
The log tray is designed to catch the log after it is split.
Tongue
The tongue is used to attach to a towing vehicle for transportation.
End Plate
The end plate holds the log in place while the wedge splits the log.
Horizontal
Beam Lock
Beam Assembly
End Plate
Wedge
Log
Tray
Vertical
Beam
Lock
4
11