Controls & Features - Troy-Bilt LS 33 TB Operator's Manual

Controls & Features
Hitch
Coupling
Jack Stand
Engine Controls
See the Engine Operator's Manual for the location and function
of the controls on the engine.
Beam Locks
The beam locks are used to secure the beam in either the
horizontal position or the vertical position. The vertical beam
lock is located next to the engine. The horizontal beam lock is
located on the beam support latch bracket.
Control Handle
Use the control handle to move the log splitter wedge forward
and backward along the beam. It has three positions; Forward,
Neutral and Reverse. See the Operation section for instructions.
Dipstick
Use the dipstick to check the hydraulic fluid level.
Horizontal
Beam Lock
Figure 4-1
Log Dislodger
The log dislodger is designed to remove any partially split wood
from the wedge while it is retracting. This may occur while
splitting large diameter wood or freshly cut wood.
Log Tray
The log tray is designed to catch the log after it is split.
Hitch Coupling
Use the hitch coupling to attach the log splitter to a towing
vehicle for transportation.
Jack Stand
The jack stand supports the log splitter while in the operating
position.
Log
Control
Dislodger
Handle
Vertical
Beam Lock
Dipstick
4
Log Tray
11