Reflector; Filter - High End Systems SHOWGUN User Manual

CHAPTER 5
Maintenance and Troubleshooting

Reflector

1. Loosen two captive screws
on each side to remove the
two side bezels
2. Loosen four captive screws
to remove the rear bezel
3. Using a 3 mm hex, remove
the four M4 screws and
slide the hot mirror mount
out of the unit.
4. Slide the reflector out of the
mirror mount.
5. Clean the reflector and
replace.

Filter

There is a washable filter
located on one side of the
electronics housing attached
with velcro. Remove, wash with
soap and water.
Allow to dry and then reattach.
44 SHOWGUN ® User Manual