Others
The image that was supposed to have uploaded to the web service is not there.
•
Upload may not complete when it is disconnected while transmitting the image.
•
It may take some time after uploading the image to be reflected in the web service depending
on the status of the server.
> Wait for a while and try again.
•
You can check the transmission status on the web service link settings by logging into "LUMIX
CLUB".
I would like to return the image in the web service to the camera.
•
The images in the web service cannot be saved (downloaded) to this unit. Do not delete the
uploaded images, and make a backup of them.
I cannot display or delete the images uploaded to the web service by this unit.
•
The images uploaded to the web service cannot be displayed or deleted by this unit.
> Perform the task using a smartphone/tablet or a PC.
Your "LUMIX CLUB" login ID and password were deleted after sending the
camera in to be repaired.
•
The settings stored in the camera may be deleted depending on the type of repair.
> Always make a copy of important settings.
There is an image that could not be transmitted.
•
Is the size of the image too large?
> Divide the motion picture using [Video Divide] (P254).
> Reduce the image size at [Size].
•
Capacity or number of images in the web service is full.
> Login to "LUMIX CLUB", and check the status of the destination on the web service link
settings.
I have forgotten the password for the Wi-Fi.
> Execute the [Reset Wi-Fi Settings] in the [Setup] menu.
> However, all the information you have set on the [Wi-Fi Setup] menu will be reset.
(excluding [LUMIX CLUB])
Transmission of the image fails midway.
•
Is the size of the image too large?
> Transmit after dividing the motion picture with [Video Divide] (P254).
> Reduce the image size at [Size] (P308), and then send.
> Image cannot be transmitted when the battery indicator is flashing red.
(P308)
366
(P60)