Connecting Ac Output Wiring; Configuring The Inverter Output Neutral Bonding - Xantrex PROSINE 2.0 User Manual

PRO 2.0 I •C
SINE NVERTER HARGER

Connecting AC Output Wiring

➢ ➢ ➢ ➢ To connect each inverter•charger to the load panel
1. Connect 2-conductor-plus-ground cable to the Line 1 PROsine
2. Run the 2-conductor-plus-ground cable to the load panel and connect:
3. Repeat steps 2 and 3, connecting the Line 2, neutral, and ground from the

Configuring the Inverter Output Neutral Bonding

Electrical codes require that you unbond the neutral-ground connection of one
of the inverter•chargers. Otherwise when the units are inverting, they will both
connect the neutral to safety ground through a relay. Installation codes
stipulate that the neutral be connected to safety ground in one—and only
one—location.
➢ ➢ ➢ ➢ To unbond the neutral in one of the inverter•chargers
1. Select one inverter•charger in which to unbond the neutral.
2. Locate and remove the neutral-ground bonding screw at the back of the
3. Install the screw in the extra hole (identified as the position in which the
4. Tighten the screw so it will not back out over time.
5. Leave the other inverter•charger's neutral-ground bonding screw in the
88
U ' M
SER S ANUAL
Inverter•Charger's AC Output line and neutral conductors, and connect
the cable's ground wire to one of the output ground screws
inverter•charger.
• The Line 1 conductor to the panel's Line 1 input breaker
• The neutral to the panel's neutral bus
• The ground to the panel's ground bus
Line 2 inverter•charger to the load panel's Line 2 input breaker, neutral
bus, and ground bus.
Generally, it does not matter which inverter•charger you select, but your
system may dictate that one unit in particular be unbonded.
AC wiring compartment.
neutral is NOT automatically bonded) so it is available for future use if
you change your system.
automatic bonding position.
on the
445-0089-01-01