Autolift Pc Board Replacement (If Applicable); Autolift Actuator (Motor) Replacement (If Applicable) - Henny Penny OEA/OGA-341 Technical Manual

2-23. AUTOLIFT PC BOARD
REPLACEMENT
(if applicable)
Autolift PC Board
Figure 2-77
2-24. AUTOLIFT
ACTUATOR (MOTOR)
REPLACEMENT
(if applicable)
Figure 2-78
Figure 2-79
2-28
1. Remove electrical power supplied to unit.
To avoid electrical shock or property damage, move the
power switch to OFF and disconnect main circuit
breaker, or unplug cord at wall receptacle.
2. Remove control panel
3. Disconnect connectors from PC board.
4. Using 5/16" nut-driver or wrench, remove the 4 nuts securing
the autolift PC board to the panel and remove PC board from
panel.
5. Install new panel in reverse order.
1. Remove electrical power supplied to unit.
To avoid electrical shock or property damage, move the
power switch to OFF and disconnect main circuit
breaker, or unplug cord at wall receptacle.
2. Drain shortening from frypot.
3. Remove basket and knock pin from basket hanger. Figure 2-78.
4. Remove rear cover. Figure 2-79.
Model OFE/OFG/OEA/OGA-341, 342
106