Error Codes - Henny Penny OEA/OGA-341 Technical Manual

1-4. ERROR CODES

DISPLAY
"E4" Control board
overheating
"E5" Shortening
overheating
"E6-A" Temperature
probe open
"E6-B" Temperature
probe shorted
"E10" High limit
"E15" Drain switch
failure
"E31" Elements not
hinged all the
way down
"E41", Programming
"E46" failure
1003
In the event of a control system failure, the digital display shows
An error message. These messages are coded: "E4", "E5", "E6",
"E10", "E15", "E20", "E31", "E41", "E46", and "E92". A
Constant tone is heard when an error code is displayed, and to
silence this tone, press any button.
CAUSE
Turn switch to OFF position, then turn switch back to ON;
if display shows "E4", the control board is getting too hot;
check the louvers on each side of the unit for obstructions
Turn switch to OFF position, then turn switch back to ON;
if display shows "E5", the heating circuits and temperature
probe should be checked
Turn switch to OFF position, then turn switch back to ON;
if display shows "E6" the temperature probe should be
checked
Turn switch to OFF position, then turn switch back to ON;
if display shows "E6" the temperature probe should be
checked to replace, per Temperature Probe Replacement
Section
Reset the high limit by manually pushing up on the red
reset button; if high limit does not reset, high limit must be
replaced per High Limit Temperature Control Section
Close drain, using the drain valve handle; if display still
shows "E-15", check the drain microswitch per Drain
Microswitch Section
Check to make sure the elements are hinged all way down
into the frypot; check for obstructions under elements
Turn switch to OFF, then back to ON; if display shows any
of the error codes, try to reinitialize the control (Special
Program Mode Section of Operator's Manual); if error
code persists, replace the control panel per Complete
Control Panel Replacement Section
Model OFE/OFG/OEA/OGA-341, 342
PANEL BOARD CORRECTION
1-5