Table of Contents
Advertisement
Changing the order of patches
(Patch Exchange function)
Use this when you want to change the order of patches.
It is not possible to change the order of the preset patches.
fig.2-33
4,6
3
8
5
2,7
1. Press [WRITE].
fig.2-32
2. Press [F6] (EXCHANGE).
The Exchange screen will appear.
fig.2-34
3. Press [F1] (PATCH A).
4. Turn the VALUE dial to select one of the patches that
you want to exchange.
5. Press [F4] (PATCH B).
fig.2-35
6. Turn the VALUE dial to select the other patch that you
want to exchange.
7. Press [F6] (EXCHANGE) to exchange the two patches.
The display will indicate "NOW EXCHANGING."
8. Press [EXIT] twice to return to the Play page.
1
Chapter 2. Creating sounds
Adjusting the sound of the
entire V-Bass according to
the performance conditions
You can adjust the sound of all patches in common.
If the location in which you are performing has more
reverberation than the location in which you created the
patches (for example, if you are performing live), you
can use this function to lower the reverb level of all
patches, instead of having to individually edit the reverb
level of each patch.
1. Press [SYSTEM].
fig.2-37
fig.2-60
2. Press [F1] (GLOBAL).
fig.2-36
3. Press [F1]–[F6] to select the parameter that you want to
adjust, and use the VALUE dial to adjust the value.
4. Adjust the parameters (p. 64) until you get the sound
you want.
5. Press [EXIT] several times to return to the Play page.
* These settings remain stored in memory even while the power
is off. You do not need to perform the Write procedure (p. 30).
31
Advertisement
Table of Contents
