Roland V-Bass Owner's Manual page 59

Chapter 5. Parameter guide
If the type is set to "P.SHIFTER"
ON/OFF
Turns each of the two pitch shifter notes on/off.
MODE
Selects the pitch shifter mode.
POLY This setting allows you to play chords.
MONO This setting has less sense of modulation (sway)
than conventional pitch shifters. Play single notes.
SHIFT
Adjusts the amount of pitch shift in semitone steps.
FINE
Makes fine adjustments to the amount of change produced
by the pitch shifter.
FEEDBACK
Adjusts the amount of feedback for the pitch shifted sound.
PRE DLY (Pre delay)
Adjusts the time from when the direct sound is heard until the
pitch shifted sound is heard. Normally, you will set this to "0 ms."
PAN
Pans the sound to left or right.
LEVEL
Adjusts the volume of the pitch shifted sound.
DIR LEV (Direct Level)
Adjusts the volume of the direct sound.
If the type is set to "FLANGER"
RATE
Adjusts the speed of modulation.
* If this is set to BPM, the value of each parameter will be set by
the tempo value (p. 23) specified for each patch. This makes it
easy to create effect sounds that are synchronized to the tempo
of your song.
DEPTH
Adjusts the depth of modulation.
MANUAL
Adjusts the center frequency at which the effect will be
applied.
58
-24–+24
-50–+50
0–100
0–300msec, BPM –BPM
L=100, R=0–L=0, R=100
0–100
0–100
0–100, BPM –BPM
0–100
0–100
RESO (Resonance)
Adjusts the amount of resonance (amount of feedback).
Increasing this value will emphasize the effect, producing a
more distinctive sound.
LOW CUT (Low cut filter)
Cuts the frequency region below the specified frequency. If
this is set to "FLAT," the low cut filter will have no effect.
SEPARATE (Separation)
Adjusts the spread. Increasing this value will produce a
wider left/right spread.
BALANCE
Adjusts the balance of the direct sound and effect sound.
LEVEL
Adjusts the volume of the flanger.
If the type is set to "PHASER"
RATE
Adjusts the speed of rotation.
* If this is set to BPM, the value of each parameter will be set by
the tempo value (p. 23) specified for each patch. This makes it
easy to create effect sounds that are synchronized to the tempo
of your song.
DEPTH
Adjusts the speed of rotation.
MANUAL
Adjusts the center frequency at which the phase effect will be
applied.
RESO (Resonance)
Adjusts the amount of resonance (amount of feedback).
Increasing this value will emphasize the effect, producing a
more distinctive sound.
STAGE
Selects the number of stages used by the phase effect.
4STAGE Four-stage phaser. Produces a light phasing ef-
fect.
8STAGE Eight-stage phaser. Produces a widely used
phasing effect.
12STAGE Twelve-stage phaser. Produces a deep phasing
effect.
BI-PHASE This is a phaser with two phase-shift circuits
connected in series.
0–100
FLAT, 55 Hz–800 Hz
0–100
D=100, E=0–D=0, E=100
0–100
0–100, BPM –BPM
0–100
0–100
0–100