Table of Contents
Advertisement
Chapter 3. System settings
Pedal function settings
Specifying the function of the
BANK pedals
1. Press [SYSTEM].
2. Press [F3] (PEDAL).
3. Press [F1] (BANK SW MODE).
fig.3-07
4. Turn the VALUE dial to select the function of the BANK
pedals.
WAIT NUM:
After changing the bank, press a number pedal [1]–[4] to
switch patches.
NUMBER 1:
When you switch banks, patch number 1 of the selected
bank will be selected.
SAME NUM:
When you switch banks, the identically numbered patch
as had been selected in the previous bank will be
selected in the newly selected bank.
5. Press [EXIT] several times to return to the Play page.
Specifying the range of banks
You can use this function when you want to limit the range
of banks that can be used (for example when you are
performing live).
1. Press [SYSTEM].
2. Press [F3] (PEDAL).
3. Press [F2] (BANK AREA(MIN)) and use the VALUE
dial to specify the lower limit of the banks that you
want to select.
fig.3-08
36
4. Press [F3] (BANK AREA(MAX)) and use the VALUE
dial to specify the upper limit of the banks that you
want to select.
fig.3-09
5. Press [EXIT] several times to return to the Play page.
Specifying the function of an
external foot switch (FS-5U)
Here you can specify the function of external foot switches
connected to the SUB CTL 1,2 jack.
1. Press [SYSTEM].
2. Press [F3] (PEDAL).
3. Press [F4] (SUB CTL1), and use the VALUE dial to
select the function of the SUB CTL 1 jack.
fig.3-10
ASSIGNABLE:
Settings can be made for each patch as a parameter
control pedal.
TUNER:
Display the Tuner screen.
TAP TEMPO:
Tap input for the MASTER TEMPO parameter.
MANUAL:
Turn Manual mode (p. 32) on/off.
FX-BYPASS:
Turn the FX-BYPASS function (p. 62) on/off.
* When you select the value other than "ASSIGNABLE," the
Assign function will have no effect even if you set the
SOURCE value in the Assign function settings (p. 26) to SUB
CTL1 or SUB CTL2.
* When you are using FS-5L or EV-5, set the value to
"ASSIGNABLE," and specify the Pedal function settings (p.
24).
4. Press [F5] (SUB CTL2), and use the VALUE dial to
select the function of the SUB CTL 2 jack.
5. Press [EXIT] several times to return to the Play page.
Advertisement
Table of Contents
