Gk Pickup Function Settings; Changing The Function Of The S1/S2 Switches; Specifying The Function Of The Gk Vol Knob - Roland V-Bass Owner's Manual

Chapter 3. System settings

GK pickup function settings

Changing the function of the
S1/S2 switches
1. Press [SYSTEM].
2. Press [F4] (GK FUNC).
3. Press [F4] (DOWN/S1,UP/S2).
fig.3-15
4. Turn the VALUE dial to select the function of the S1/S2
switches.
ASSIGNABLE:
Allows settings to be made in each patch as parameter
control buttons.
MASTER LEVEL:
Increases/decreases the MASTER LEVEL.
PEDAL FUNC:
By holding down the S1/S2 switch and pressing a pedal
you can control functions that are assigned as follows.
Number pedal [1]: MASTER LEVEL down
Number pedal [2]: MASTER LEVEL up
Number pedal [3]: TUNER
Number pedal [4]: TAP TEMPO
V-Bass CTL pedal: Control pedal
V-Bass EXP pedal: FOOT VOLUME
BANK pedal: FX-BYPASS
BANK pedal: MANUAL
PATCH SELECT:
Increment/decrement the patch number.
BYPASS/MANU:
The S1 switch is assigned FX-BYPASS, and the S2 switch
is assigned the MANUAL on/off function.
TUNER/TEMPO:
The S1 switch is assigned Tuner on/off, and the S2
switch is assigned the TAP TEMPO function.
5. Press [EXIT] several times to return to the Play page.
38
Specifying the function of the
GK VOL knob
1. Press [SYSTEM].
2. Press [F4] (GK FUNC).
3. Press [F6] (GK VOL).
fig.3-16
4. Turn the VALUE dial to select the function of the GK
VOL knob.
ASSIGNABLE:
Allows settings to be made in each patch as a control
knob. Depending on the parameter that is assigned, the
GK-2B select switches may not operate.
PICKUP LEVEL:
Control the pickup output level used in the COSM BASS
block.
MIXER LEVEL:
Control the COSM BASS "MIXER LEVEL."
MASTER LEVEL:
Control the "MASTER LEVEL"
* The "PICKUP LEVEL" will come into effect only when you
select "ACOUSTIC", "ELECTRIC", "VARI BASS", "PD
SHIFT", "POLY OCTAVE", "POLY DISTORTION", or
"POLY SLOW GEAR" for the COSM BASS type.
* If this is set to anything other than "ASSIGNABLE," the
setting of the PEDAL ASSIGN parameter GK VOL will be
ignored.
5. Press [EXIT] several times to return to the Play page.
The settings for the parameters described in this chapter,
will remain after the power is turned off. You do not
need to perform the Write procedure (p. 30).