Table of Contents
Advertisement
If the COSM BASS parameter TYPE
is set to "VARI BASS"
REAR TYPE
Specify the type of rear pickup.
FRONT TYPE
Specify the type of front pickup.
SINGLE
Use a single-coil pickup.
DOUBLE
Use a double-coil pickup.
PIEZO
Use a piezo pickup.
LEVEL
Adjust the volume of the pickup. With a setting of "0," no
sound is produced.
CONTROL
2VOL-2TONE
Two volume and two tone controllers.
Two volume and one tone controller.
2VOL-1TONE
BALANCE
One balance and one tone controller.
2BAND
Bass and treble controllers.
R.VOL (Rear Volume)
Adjusts the volume of the rear pickup.
F.VOL (Front Volume)
Adjusts the volume of the front pickup.
R.TONE (Rear Tone)
Adjusts the tone of the rear pickup.
F.TONE (Front Tone)
Adjusts the tone of the front pickup.
TONE
Specifies the tonal character of the pickup. Positive (+)
settings will boost the volume of the upper range, and
negative (-) settings will decrease the volume.
BALANCE
Adjusts the balance between the front and rear pickups.
BASS
Adjusts the tone of the lower range.
TREBLE
Adjusts the tone of the upper range.
0–100
0–100
0–100
-50–+50
-50–+50
-50–+50
R=100, F=0–R=0, F=100
-50–+50
-50–+50
Chapter 5. Parameter guide
R.POSI (Rear Position)
Specifies the location of the rear pickup in terms of the
distance from the bridge. Higher settings will simulate a
greater distance between the pickup and bridge.
* It is not possible to set the position if "PIEZO" is selected as
the pickup type.
F.POSI (Front Position)
Specifies the location of the front pickup in terms of the
distance from the bridge. Higher settings will simulate a
greater distance between the pickup and bridge.
* It is not possible to set the position if "PIEZO" is selected as
the pickup type.
REAR PICKUP OFFSET Hi–Lo -445–+445 mm
Finely adjust the rear pickup position for each string.
* It is not possible to set the offset if "PIEZO" is selected as the
pickup type.
FRONT PICKUP OFFSET Hi–Lo -445–+445 mm
Finely adjust the front pickup position for each string.
* It is not possible to set the offset if "PIEZO" is selected as the
pickup type.
R.PHASE (Rear Phase)
Specify the phase of the rear pickup when mixing the front
and rear pickups.
IN
The rear pickup will be mixed in normal phase.
OUT The rear pickup will be mixed in reverse phase.
F.PHASE (Front Phase)
Specify the phase of the front pickup when mixing the front
and rear pickups.
The front pickup will be mixed in normal phase.
IN
OUT The front pickup will be mixed in reverse phase.
5–450 mm
5–450 mm
45
Advertisement
Table of Contents
