Table of Contents
Advertisement
Chapter 5. Parameter guide
NS (Noise suppressor)
This effect reduces the hum and noise that are picked up by
the pickups of a bass. Since the noise is reduced according to
the envelope (the change in volume over time) of the bass
sound, it produces a natural result without significantly
affecting the sound of the bass.
* Connect the noise suppressor before reverberation-type effects.
This will prevent the reverberation-type effect from being cut
off unnaturally.
ON/OFF
Switches NS on/off.
THRESHOLD
Adjust this according to the amount of noise. Increase the
value if there is much noise, or decrease it if there is little
noise. Adjust this parameter so that the bass sound decays
naturally.
* If the threshold is set to a high value, there may be no sound if
you play your bass with its volume turned down.
RELEASE
Adjusts the time from when the noise suppressor begins to
operate until the volume reaches "0."
FV (Foot volume)
LEVEL
Adjusts the volume.
SET PDL (Setting Pedal)
Assigns the Foot Volume function to the V-Bass's EXP pedal.
FX-BYPASS
ON
All the effects excluding NS and FV are bypassed in
the EFFECTS section. Even if an effect is turned on, it
will be the same as if it were turned off.
OFF
The effects of the EFFECTS section will not be by-
passed. Each effect will process the sound according
to its settings.
* This will not effect on COSM BASS and COSM AMP.
62
Use this if you want to control parameters while you perform
by using the V-Bass's EXP pedal or CTL pedal, or by using an
external pedal or external MIDI device connected to the V-
Bass.
* Turn "ON" the effect to which the parameter being controlled
belongs.
EXP (ON/OFF)
Switch the EXP pedal on/off.
* You can turn the VALUE dial to select PRESET.
0–100
CTL (ON/OFF)
Switch the CTL pedal on/off.
* You can turn the VALUE dial to select PRESET.
GK VOL (ON/OFF)
Switch the GK volume on/off.
* You can turn the VALUE dial to select PRESET.
* Set the GK FUNC parameter GK VOLUME to
0–100
"ASSIGNABLE" (p. 25).
GK S1/S2 (ON/OFF)
Switches the GK S1/S2 on/off.
* You can turn the VALUE dial to select PRESET.
* Set the GK FUNC parameters DOWN/S1 and UP/S2 to
0–100
"ASSIGNABLE" (p. 24).
ASSIGN1–8 (ON/OFF)
Switches ASSIGN 1–8 on/off.
* You can turn the VALUE dial to select PRESET.
TARGET
Selects the parameter to be controlled.
* Regardless of the settings of COSM BASS, COSM AMP, and
EFFECTS, the parameters listed in "PEDAL ASSIGN
parameter list" (p. 71) can be selected as the TARGET.
MIN (Minimum)
Specify the minimum value of the adjustable range.
MAX (Maximum)
Specify the maximum value of the adjustable range.
PEDAL ASSIGN
Advertisement
Table of Contents
