Table of Contents
Advertisement
Chapter 5. Parameter guide
SYSTEM
GLOBAL
These parameters let you change various settings for all
patches in common. This allows you to leave the settings of
each patch unmodified, while changing the settings as
appropriate for the equipment you are using, or the location
in which you are performing.
ON/OFF
Switches the Global function on/off.
LOW G (Low Gain)
Adjusts the tone of the lower range.
* This adjusts the tone regardless of the equalizer on/off setting
in each patch.
HIGH G (High Gain)
Adjusts the tone of the upper range.
* This adjusts the tone regardless of the equalizer on/off setting
in each patch.
NS (Noise suppressor)
Applies a -20 dB–+20 dB adjustment to the noise suppressor
threshold level specified within each patch. It is useful to
adjust this if you have connected a different bass, or if you
want to make adjustments appropriately for the output level
of your bass.
* Set this to "0 dB" if you want to use the value specified by
each patch.
* This will have no effect on patches in which the noise
suppressor is turned off.
REVERB
Applies an adjustment in the range of 0%–200% to the reverb
level specified within each patch. It is useful to adjust this as
appropriate for the reverberation of the location in which
you are performing.
* Set this to "100%" if you want to use the value specified by
each patch.
* This will have no effect on patches in which reverb is turned
off.
LEVEL
Adjusts the output level. You can make adjustments
according to the input level of the connected device.
Normally, you should set this "0."
64
-20–+20 dB
-20–+20 dB
-20–+20 dB
0%–200% (101 steps)
-50–+50
DISPLAY CONTRAST 1–16
Depending on the location in which the V-Bass is used, the
display may be difficult to read. In this case, adjust the
display contrast (brightness).
PEDAL FUNCTION
These settings specify how the V-Bass's pedals or external
pedals will operate.
BANK SW MODE (Bank switch mode)
Specifies how patches will change when you press the BANK
pedals.
After changing the bank, press a number ped-
WAIT NUM
al [1]–[4] to change patches.
NUMBER 1
When you change banks, patch number 1 of
the newly selected bank will be selected.
SAME NUM When you change banks, the identically num-
bered patch (as the patch that had been select-
ed in the previous bank) of the newly selected
bank will be selected.
BANK AREA (MIN)
(Bank area (minimum))
Specifies the lower limit of the bank pedals.
BANK AREA (MAX)
(Bank area (maximum)
Specifies the upper limit of the bank pedals.
SUB CTL1 (Sub control pedal 1)
SUB CTL2 ( Sub control pedal 2)
Specifies the operation of external devices connected to the
SUB CTL 1,2 jack.
ASSIGNABLE
The function will be specified by the pa-
rameter control pedal setting within each
patch.
TUNER
Displays the tuner screen.
TAP TEMPO
Tap input of the MASTER TEMPO param-
eter.
MANUAL
Switches Manual mode (p. 28) on/off.
FX-BYPASS
Switches FX-BYPASS (p. 62) on/off.
* If this is set to anything other than "ASSIGNABLE," the
ASSIGN 1–8 source SUB CTL1 and SUB CTL2 settings will
be ignored.
1–50
1–50
Advertisement
Table of Contents
