Ptz & Rs-485 Setup - Security Labs H.264 Owner's Manual

Pan/Tilt/Zoom (PTZ) or Speed Dome cameras can be operated from this DVR. Please
connect your control data cable (typically one twisted pair in a CAT5 cable) to the RS485-
(Pin #1) and the RS485+(Pin #14) on the back panel (illustrations shown in Chapter 1).
Please make sure polarity (+ and -) is observed. The video cable can be connected to
any input on the DVR. Protocol is a type of language or combination of hex data used
for communication between devices. Standard protocols are used to allow
interoperability between manufacturers.
data is sent to a device.
The most important step in setting up a PTZ camera is to make sure the Protocol
type, PTZ I.D., and Baud Rate selected on the screen above MATCH the settings of
your PTZ camera. Protocol = Pelco D or Pelco P, Baud rate = 9600, and PTZ I.D. = 1
are the most common settings used. Please check the owner's manual of your PTZ
camera to confirm or adjust its settings.
Item
Enable PTZ
Protocol
PTZ ID
Baud Rate
RS-485 ID
RS-485 Baud Rate
Keyboard
3.8 PTZ & RS-485 Setup
Click the box to Enable/Disable the PTZ function for the channel selected
Pelco P, Pelco D, KND, LiLin, LG, and Samsung are available
Click or press ◀ ▶ to change the PTZ ID from 1 to 64.
Select a Baud Rate from 2400, 480, 9600, or 19200
*Functions are available for matching with existing wired remote
systems.
Baud rate is the speed at which the protocol
Description
41