Table of Contents
Advertisement
Item
Motion Alarm
Duration(Seconds)
Motion Popup
Enable
Sensitivity
(A lower value = less)
Motion Area Setup
3.3.1.1 Motion Area Setup
Right click on the grid screen to activate the sub menu above.
The motion detection grid is made up of 330 small squares (22x15 pattern). The
concept is to make squares transparent where you want motion to be detected, and
mask RED any squares that should not detect motion.
accomplish this is to make all squares transparent (active) with the "All Area
Alarm duration time (1~60 seconds). Sets the length of a recording after
motion is detected
Check the box to Enable/ Disable the popup screen function for ALL
channels. When motion is detected during LIVE view mode, the detected
channel's image will then show in full screen display.
Select a channel number from the bar list, and check the box to Enable,
or uncheck to Disable motion detection for that channel. This gives you
a way to choose channels that will use motion detection, and a way to
temporarily disable a channel without affecting its other motion settings.
Drag the bar, click the arrows◀ ▶, or click on the box to set up a Sensitivity
value from 0 to 10 for each channel.
sensitivity.
Click to enter the motion grid selection screen described below
21
Description
A lower value equals less
The quickest way to
Advertisement
Table of Contents
