Utility Setup - Security Labs H.264 Owner's Manual

3.10 Utility
Item Description
Select to enter the hard disk initialization menu. This step should be
HDD Initialization (Format).
performed whenever installing a new hard drive, or if you change the time /
THIS STEP WILL ERASE
date settings on your DVR. Please stop recording before entering
ALL VIDEO DATA
this menu. System will show all the data (model/ volume) of HDD that is
FROM YOUR HARD
installed in the DVR. Check the HDD you'd like to initialize, and then press
DRIVE.
"Start". HDD initialization is successful when the status shows "Succeed".
Clears all data on your USB drive. . Enter USB initialization and press "YES".
USB Initialization
The initialization is done when "Succeed" is displayed.
System Recovery Restores all settings to factory default values.
Clears the event logs.
Reset System Events
You can transfer your setup configuration to another (same model) DVR
Copy Setup to USB using this command via a USB flash drive. There will be a file named
"sdvr.config" on your USB drive when finished.
Download the configuration file from a USB device into the same model
Download Setup from USB
DVR.
The operational firmware for your DVR can be upgraded if needed.
Please contact Customer Service @ 800-774-0284 for details first. An
Upgrade improper file installed can also render your unit inoperable! Please stop
recording and backup setup configuration before upgrading.
System will reboot automatically when the upgrade is completed.
49