Sensor Setup - Security Labs H.264 Owner's Manual

Detection" command, and then mask the ones that will be inactive with your mouse.
If most of the camera channel is to be inactive similar to the example above, then
select the "Mask All Area" command and then select the squares you wish to be
active (transparent) with your mouse.
Item
Mask Mouse Selection
All Area Detection
Mask All Area
Continue
Exit & Save
Exit & Discard

3.3.2 Sensor Setup

Please Note: The Sensor / Alarm Input feature will not operate until enabled in
Schedule Setup (next section 3.4).
Another way to conserve hard drive space and tag important events for fast access in the
future is to involve sensors to activate your DVR. PIR (passive infrared) motion detectors,
magnetic door switches, alarm panel relay outputs, etc., are just a few of the many ways to
Check the box = mouse will mask squares.
Uncheck the box = mouse will make squares transparent.
Makes the entire screen active (transparent)
Mask (red) the entire screen (inactive)
Temporarily turns the selection box OFF while you edit the screen. Right
click on the screen to turn the selection box back ON.
Save setup and exit setup page.
Cancel setup and exit setup page.
22
Description