Table of Contents
Advertisement
Software Control
This section describes the control software for the DMP 44 LC, including:
•
•
Software Control
The DMP 44 LC can be controlled using the DSP Configurator software, SIS commands
through HyperTerminal or DataViewer.
The DMP 44 LC has the following connection options:
•
•
The DSP Configurator Control Program is compatible with Windows 2000,
Windows XP, Windows Vista
attenuation, output volume output adjustment, and other features.
DSP Configurator can control the DMP 44 LC via any of the two control ports, RS-232 or
USB.
Updates to this program can be downloaded from the Extron website at
www.extron.com.
Installing the DSP Configurator Program
The program is contained on the Extron Software Products DVD.
Install the software as follows:
1.
2.
Software Control
DSP Configurator Program
RS-232 — One single stack 6-pole (shared with Digi In), 3.5 mm captive screw
connector is used for bi-directional RS-232 (±5 V) serial control.
See
"Rear Panel Features and
RS-232 port.
USB 2.0 — A Mini B-type USB connector located on the front panel provides
high-speed USB 2.0 connectivity to a host computer, backward compatible to 1.0.
, and provides remote control of the input gain and
®
Insert the DVD into the drive
Click the Software tab or software icon.
NOTE:
If the DVD setup program does not start automatically, run
from the DVD ROM directory in "My Computer" of the Windows
operating system.
Cabling", for additional details on connecting the
DMP 44 LC • Software Control
Launch.exe
51
Advertisement
Table of Contents
