Extron electronics DMP 44 LC User Manual page 66

Saved presets can be recalled via the DSP Configurator, or a control system sending an
SIS preset recall command. Presets may also be saved and recalled via the embedded web
page. Presets saved via the web page contain input gain, output volume, and the primary
mix-point settings.
Previewing/Recalling a Preset
A preset can be previewed in either Live or Emulate mode by selecting the preset from the
presets drop-down list.
Figure 32.
The program indicates a view-only preset configuration by displaying each preset element
with a translucent green mask over the block. In the example, the input processors are
included in Preset 1 - Input Procs.
Behavior for previewing and applying presets is as follows:
Live Mode — After selecting a preset, DSP Configurator displays the preset elements
•
that will be affected by a preset recall with a translucent mask over the element, and
leaves all other DSP Configurator elements unaltered. Elements without a translucent
mask represent elements in the current state that will be unaffected by a preset
recall. Real-time changes to the current state will not be reflected in the GUI while
previewing a preset, and the user cannot alter GUI elements. To apply the preset, the
user clicks Recall. The preset reverts to "Current State."
• Emulate Mode — After selecting a preset from the list, DSP Configurator displays the
elements that will be affected by a preset recall with a green translucent mask, leaving
all other elements (which represent the current emulation) unaltered. The user clicks
Recall to apply the viewed preset to the current emulation. The preset number
reverts to "Current Emulation."
Preset Preview
DMP 44 LC • Software Control 60