Glass Door Replacement - Temco DV1000DSN Homeowner's Installation And Operating Manual

Dv1000/1200/1400dsn/dsp series direct vent zero clearance, gas fireplace heater

Hide thumbs

Table Of Contents

Table of Contents

Cleaning should include burner tubes, orifice/injectors

(refer to section B.3 National Fuel Gas Code), logs,

ceramic base, and pilot assembly. It is recommended

that the sediment trap in the gas line be emptied and

cleaned at this time. (See Section 3.7.2 National Fuel

Gas Code)

Burner, Pilot, Firebox and Logs

CAUTION: Before cleaning or moving logs

or other parts of the unit, be sure to read the

section on important safeguards.

Cleaning should be done before the logs are used

each year and after long periods of non-use. All clean-

ing should be carried out when the appliance is cold.

Cleaning will be required under normal use. Dusting

the front grate or the control knob panel may be re-

quired occasionally. Do not use any cleaning fluids to

clean the logs or any other part of the appliance.

If the flames show any unusual shapes or behavior, or

if the burners fail to ignite properly, then the burner

holes may require cleaning. If this occurs, contact your

nearest dealer to get the appliance serviced.

Alternatively, the appliance can be cleaned by remov-

ing all the logs. Handle the logs gently so as not to

damage them. Always lift each log by holding it care-

fully at each end.

After the logs are removed allowing access to the

burner area, use a vacuum cleaner to carefully remove

dust and loose particles from the base, logs and from

around the burners. Gloves are recommended to

prevent the ceramic fibers that compose the logs from

pricking your skin. If the skin is pricked, wash gently

with soap and water. Use extreme caution in cleaning

around the pilot . The pilot should not be moved or

altered from the original factory setting (Pilot to burner

preset location). The burner should be placed back

into its original locked and secure position after clean-

ing and servicing(proper location of burners are criti-

cal). NOTE: All replacements and repairs should be

performed by a qualified technician (contact your

nearest dealer). After cleaning and/or repairs, follow

instructions for positioning of logs as illustrated on

Page 24.

77045

Temco DV1000/1200/1400DSN/DSP Series

Glass

It will be necessary to clean the glass periodically.

During startup it is normal for condensation to form on

the glass and cause dirt, lint, etc., to adhere to the

inner surface of the glass. There also will be a film

deposited on the glass during the initial use of the

fireplace due to initial curing of the paint. It is recom-

mended that the glass be cleaned with a non-abrasive

household cleaner and warm water. Be sure to rinse

and dry the glass well as not to leave any marks. It will

be necessary to clean the glass up to 3 times a season

depending on use of the fireplace.