Operating Instructions; Glass Information; Louvre Removal; Window Frame Assembly Removal - Temco 36CDVRRN Installation Instructions And Homeowner's Manual

Builder direct vent
Table of Contents

Advertisement

CDV Series Direct Vent Gas Fireplace

Glass Information

Only glass approved by CFM Corporation
should be used on this fireplace.
The use of any non-approved replacement glass will
void all product warranties.
Care must be taken to avoid breakage of the glass.
Do not operate appliance with glass front
removed, cracked or broken.
Replacement glass (complete with gasket) is
available through your CFM Corporation dealer
and should only be installed by a licensed
qualified service person.

Louvre Removal

The top louvre panel
is removed by lifting
the panel vertically and
pulling it away from the
appliance. (Fig. 57) The
lower access door is
removed in the same
manner.

Window Frame Assembly Removal

1. Turn the fireplace OFF (including the pilot)
2. If the unit has been operating allow time for the
components to cool.
3. Remove the top louvre assembly.
4. Remove the lower louvre panel.
5. Release the two clamps securing the lower edge of
the window frame assembly by pulling down on the
handles. (Fig. 58)
6. Tilt the window frame assembly out slightly at the
bottom, lift the window frame assembly up and away
from the fireplace.
7. To replace the window frame assembly reverse
the procedure.
28

Operating Instructions

2.
Louvre
1.
Glass Panel
FP1602
Fig. 57 Remove top louvre
assembly.
FP1601
Louvre removal
12/05
Window
Frame
Assembly
Fig. 58 Window frame assembly removal.

Glass Cleaning

It is necessary to periodically clean glass. During start-
up condensation, which is normal, forms on the inside
FP1228
of the glass. This condensation causes lint, dust and
remove glass frame
other airborne particles to cling to glass surface.
11/02
Also initial paint curing may deposit a slight film on
the glass. It is therefore recommended the glass be
cleaned two or three times with a non-ammonia based
household cleaner and warm water (We recommend
gas fireplace glass cleaner) within the first few weeks of
operation.
After the initial cleaning process the glass should be
cleaned two or three times during each operating
season depending on the environment in the house.
Clean glass after first two weeks of
operation.
Do not clean glass when hot.
Do not use abrasive cleaners.
Do not strike or slam the glass.
Lower Clamps
Window
Frame
Assembly
Pull Clamp
Hook
Push
Clamp
Handle
FP1228
20010175

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

36cdvtrn

Table of Contents