Optional - Connecting Vcrs To The System; Optional - Connecting To An Over-The-Air Antenna Or Cable - Dish Network 512 User Manual

Optional - Connecting VCRs to the System

The diagram below provides examples of how to connect VCRs to your satellite
TV system. Your particular installation may differ from these examples.
Connecting a VCR to the Nearby TV
1. Connect a coaxial cable from the
nearby VCR's tuner input port.
2. Connect a coaxial cable from the output on the VCR to the nearby TV's
tuner input port.
3. Plug in and turn on the nearby VCR and TV.
4. Set the VCR output to Channel 3 or 4, as selected on page 27.
5. Tune the nearby VCR and TV to Channel 3 or 4, as selected on page 27.
6. You can place a
on or near the nearby TV. This sticker will remind you which channel to use
on this TV to watch satellite programming. The stickers are located in the
inside front cover of this guide.
Optional - Connecting to an Over-the-Air Antenna or
Cable
If you want to receive channels from an over-the-air antenna or cable in addition
to your satellite receiver programming, connect the over-the-air antenna/cable
into your TV distribution equipment.
For the nearby TV receiving programming from
antenna cable needs to be connected to the
CH 3-4 OUT
channel sticker (Channel 3 or 4, as selected in step 5)
TV1
TV A
Optional - Connecting VCRs to the System
output on the receiver to the
, the over-the-air
CH 3–4 O
UT
port.
/C I
NTENNA ABLE N
Page 31