Adding Ingredients - Russell Hobbs 14449 Instructions Manual

10 Turn the lid anti-clockwise (L) till the tab is above the
handle, and the latch clicks into the safety interlock.
11 Push the cap into the hole in the lid.
12 If you run the blender without the cap, solid ingredients
may be ejected through the hole when they hit the blades.
the control
13 The control has 4 positions:
0 off
1 low – light work, using mainly liquid ingredients
2 high – heavier jobs, using mainly solid ingredients
Y gives a short burst at high speed – in this direction, the
control is spring-loaded (let go, and it'll return to 0)
14 Don't run the motor for more than 3 minutes, or it may
overheat. After 3 minutes, let it cool for at least 3 minutes.

adding ingredients

15 To add ingredients during use, remove the cap, pour the
new ingredients through the hole, then replace the cap.
16 Check that the added ingredients don't push the volume in
the jug past the 1500ml mark.
finished?
17 Turn the control to 0, and wait till the blades stop moving.
hot liquids
18 Higher temperatures may soften the lid enough to lose its
seal, allowing the contents to escape, so, when using hot
liquids:
a) before pouring into the blender, let the liquid cool to
the sort of temperature you can handle comfortably (i.e.
liquid temperature below 40°C)
b) put a hand on the lid, to hold it in place while blending
c) if the lid is too hot for comfort, remove it and let the
liquid cool further – replace the lid before blending
5