Fitting The Lid; Before Using For The First Time - Russell Hobbs 14449 Instructions Manual

17 Don't let the jug overflow. If liquid gets under the motor
unit, it may be sucked into the motor, damaging it.
18 Don't fill the jug above the 1500ml mark, or the contents
may force the lid off when you start the motor.
19 Don't run the motor for more than 3 minutes, or it may
overheat. After 3 minutes, let it cool for at least 3 minutes.
20 Don't use the blender for any purpose other than those
described in these instructions.
21 Don't run the blender empty, it may overheat.
22 Don't use the blender if it's damaged or malfunctions.
23 If the cable is damaged, return the blender, to avoid hazard.

before using for the first time

Turn to "care and maintenance" on page 6, and clean the
blender, to remove any manufacturing residues, dust, etc.
preparation
1 Sit the motor unit on a dry, firm, level surface.
2 Route the cable so it doesn't overhang, and can't be
tripped over or caught.
3 Check that it's switched off – turn the control to 0.
4 Put the plug into the power socket.
5 Hold the jug above the motor unit, with the handle
between the control and the u arrow on the motor unit.
6 Lower the jug on to the motor unit, then turn the jug to
align the handle with the u arrow on the motor unit.
7 Turn the lid clockwise to unlock it (U), then lift it off the jug.
8 Fill the jug – don't fill past the 1500ml mark, or the contents
may force the lid off when you start the motor.

fitting the lid

9 Hold the lid with the tab between the handle and the front
locking lug, then lower it on top of the jug.
household use only
4