Care And Maintenance - Russell Hobbs 14449 Instructions Manual

care and maintenance

1 Switch off (0), and unplug the blender.
2 Clean as soon after use as possible, to prevent residues
setting inside the jug.
3 Remove the jug from the motor unit.
4 Wash the jug, lid and cap in warm soapy water, rinse well,
then turn the jug upside down to drain and dry.
5 Keep your hands away from the blades – they're
sharp. Use a washing-up brush.
6 We don't recommend putting the jug, lid or cap into a
dishwasher. The extreme environment inside the
dishwasher can affect the surface finishes.
7 Wipe the outside of the motor unit with a damp cloth.
8 Don't put the motor unit in water or any other liquid.
9 Don't use harsh or abrasive cleaning agents or solvents.
blade unit
10 You may remove the blade unit for cleaning.
11 Handle only the plastic. Take care not to touch the metal
parts of the blades.
12 Do this with the jug upside down.
13 Grip the jug handle with one hand.
14 Grip the plastic part of the blade unit with the other hand.
15 Turn the blade unit anti-clockwise till it comes loose from
the jug (about 2 cm).
16 Carefully, pull it out of the bottom of the jug.
17 It's a close fit, so you'll have to move it around a bit, to get
it out of the jug.
18 Slip the end of a knife under the edge of the seal, and lift
the seal away from the blade unit.
19 Wash the seal and blade unit in warm soapy water, rinse,
and air dry.
6