Table of Contents
Advertisement
preparation
1 Sit the motor unit on a dry, firm, level surface, close to a power socket and out of
reach of children.
2 Route the cable so it doesn't overhang, and can't be tripped over or caught.
3 Align the arrow d on the jug base with the open padlock U on top of the motor
unit, lower the jug on to the motor unit, then turn the jug to bring the arrow d over
the closed padlock L on top of the motor unit.
4 Pull the lid up and off the jug – it's stiff, because of the seal.
5 Put the ingredients into the jug. Don't fill it past the 1250ml mark. If you do, the
contents may force the lid off when you start the motor.
fitting the lid
6 Don't use the blender without fitting the lid. The contents may escape; you may hurt
someone; you may be tempted to put a hand into the jug.
7 Put the lid on the jug, and push it down to seal it.
8 Align the pips on the sides of the cap with the slots in the hole in the lid, put the cap
into the hole, and turn anti-clockwise to lock it.
9 Don't run the blender without the cap, solid ingredients may be ejected through the
hole when they hit the blades.
power up
10 Check that the speed control is set to Y.
11 Put the plug into the power socket (switch the socket on, if its switchable).
speed control
12 Turn the speed control clockwise to the speed you want. The range is from 1 (low) to
12 (high).
13 Turn the speed control back to Y to turn the motor off.
14 You'll no doubt have your own preferences, but, generally, use lower speeds for
lighter applications (e.g. using mainly liquid ingredients), and higher speeds for
heavier applications (e.g. using mainly solid ingredients).
15 Turning the speed control anti-clockwise to f will give you a short burst at high
speed. In this direction, the knob is spring-loaded. When you let go, it'll return to Y.
16 Use the f function to crush ice, and as a "pulse" function.
17 Don't run the motor continuously for more than 3 minutes, it may overheat. After 3
minutes switch off for at least 3 minutes, to recover.
turbo button Y
18 Pressing the turbo button will over-ride the speed set by the speed control, and give
you a burst of high speed, if you come across a dense area in the mixture, or if you
want to liven it up a bit.
19 The turbo button Y only works when the motor is already running (i.e. at speed 1 or
above).
adding ingredients
20 To add ingredients while the blender is working, turn the cap clockwise to unlock it,
lift it off, pour the new ingredients through the hole, then replace the cap, and turn
it anti-clockwise to lock it in place.
21 Check that the added ingredients don't push the volume in the jug past 1250ml.
4
Advertisement
Table of Contents
