Before Use; Using The Blender; Adding Ingredients - Russell Hobbs 18990 Instructions And Warranty

Before Use

Before using your appliance for the first time, wash the jug, lid and cap in warm soapy
water, rinse well and dry. NOTE: The blades are sharp, handle with care.
Preparation
1. Position the motor unit on a dry, firm, level surface, close to a power socket
and out of reach of children.
2. Check that the control knob is set to OFF (0).

Using the Blender

1. Align the arrow on the bottom of the jug with the UNLOCK symbol on the motor unit.
2. Lower the jug on to the motor unit, then turn the jug to align the arrow with the LOCK
symbol.
3. Press the lever to open the lid.
4. Put the ingredients into the jug.
Don't fill past the 1500ml mark. If you do, the contents may force the lid off when you
5.
start the motor.
6. Fit the lid to the jug.
7. Align the pips on the cap with the slots in the hole, fit the cap, and turn it clockwise to
lock it.
8. To add ingredients while the blender is in operation, remove the cap, pour the new
ingredients through the hole, then replace the cap.
Check that the added ingredients don't push the volume in the jug past the 1500ml
9.
mark.

Adding ingredients

If you need to add ingredients while the blender is working, lift the cap off, pour
the new ingredients through the hole, then replace the cap. Make sure that the
added ingredients do not push the volume in the jug past the 1500ml mark.