Table of Contents
Advertisement
Available languages
Available languages
5.
Put the ingredients into the jug.
6.
Don't fill past the 1500ml mark. If you do, the contents may force the lid off when you start the motor.
7.
Place the lid onto the jug with the tab as shown in figure A.
8.
Twist the lid clockwise to lock it (fig. B)
9.
Push the cap into the hole in the lid.
10. Don't run the appliance without fitting the cap.
11.
Check that the speed control is set to 0.
12.
Put the plug into the power socket.
USING YOUR BLENDER
•
Don't run the motor continuously for more than 3 minutes because it may overheat. After 3 minutes
switch off for at least 10 minutes to allow the motor to cool.
•
Your blender will stop operating if it overheats. If this happens, unplug your blender and let it cool
down for at least 15 minutes before using it again.
1.
Turn the speed control to the speed you want (1 = low, 2 = high).
2.
Turn the speed control back to 0 to turn the motor off.
3.
Generally, large quantities, thick mixes, and a high ratio of solids to liquids suggest longer timings
and slower speeds.
4.
Smaller quantities, thinner mixes, and more liquids than solids suggest shorter timings and higher
speeds.
PULSE
Turning the speed control anti-clockwise to Y will give you a short burst at high speed. In this direction,
the knob is spring-loaded. When you let go, it'll return to 0.
ADDING INGREDIENTS
To add ingredients while the blender is working, remove the cap, pour the new ingredients through the
hole, then replace the cap.
Check that the added ingredients don't increase the volume in the jug past the 1500ml mark.
CARE AND MAINTENANCE
1.
Switch the appliance off (0) and unplug it.
2.
Wipe the outside of the motor unit with a clean damp cloth.
3.
Wash the removable parts in warm soapy water, rinse well, drain, and air dry.
` You may wash these parts in a dishwasher.
•
If you use a dishwasher, the harsh environment inside the dishwasher will affect the surface finishes.
•
The damage should be cosmetic only, and should not affect the operation of the appliance.
BLADE UNIT
You may remove the blade unit for cleaning. This is best done with the jug turned upside down.
1.
Grip the jug handle with one hand.
2.
Grip the bottom of the blade unit with the other hand.
3.
Turn the blade unit clockwise till it comes loose from the jug base.
4.
Carefully, pull it up and out of the bottom of the jug.
5.
Lift the seal away from the blade unit.
6.
Wash the seal and blade unit in warm soapy water, rinse, and air dry.
4
Advertisement
Table of Contents
