Default Setup - Intermec EasyCoder F4 Installation & Operation Manual

Default Setup

Intermec EasyCoder F4 – Installation & Operation Ed. 3
The printer's default setup is listed below:
Ser-Com "uart1:"
Baud rate:
Character length:
Parity:
Stop bits:
RTS/CTS:
ENQ/ACK:
XON/XOFF, data to host:
XON/XOFF, data from host:
New line:
Receive buffer:
Transmit buffer:
Feedadjust
Startadjust:
Stopadjust:
Media
X-start:
Width:
Length:
Media type:
Paper type:
Ribbon constant:
Ribbon factor:
Label offset:
Low diameter;
Contrast:
Print Defi nes
Print speed:
Reading the Current Setup
The printer's current setup values can be read from the printer's
display window by browsing through the Setup Mode, or from the
host by browsing through the Terminal Setup of Intermec Shell.
You can list the printer's current setup by printing test label #5 in
the Setup Mode or by using Intermec Shell.
The current setup can be sent to the host via the standard serial
communication channel using a SETUP WRITE "uart1:"
statement (see Intermec Fingerprint v7.xx, Reference Manual).
Chapter 7 Setting Up the Printer
9600 bps
8 bits
None
1 bit
Disable
Disable
Disable
Disable
CR/LF
300 bytes
300 bytes
0
0
24
832
1200
Label (w Gaps)
Thermal Transfer
90
25
0
36
±0%
100 mm/sec.
45