Using The Cursor (At Selected Position) - Eclipse AVN726EA Owner's Manual

Operation
Navigation Overview
Icon
GPS reception quality shows the current accuracy of the position information.
Icon
ATTENTION
Touch the following status field to open the Quick menu (See page 50).
Icon

■ Using the Cursor (at selected position)

First, place the Cursor at the desired map location with one of the following options:
● Use the Find menu to select a location. The map returns with the selected point (the Cursor)
in the middle, and the Cursor menu appears with the available options.
● Touch the screen twice to place the Cursor at the desired location. Touch the cursor to open
the [Cursor] menu.
The following actions are available.
Touch switch
[Set as Destination]
[Insert as Via]
72
72
Type
Distance information
GPS receiver not connected. GPS navigation is not possible.
Navigation is connected to the GPS receiver, but the signal is too weak
and the receiver cannot determine the GPS position. GPS navigation is
not possible.
GPS navigation is not possible.
Only a few satellites are received. Position information is available, but
elevation (altitude) cannot be calculated. GPS navigation is possible,
but the position error may be significant.
Altitude information is available, the position is a 3D position.
GPS navigation is possible.
Status
GPS position quality
On an active route, use the Cursor as the destination by resetting the
previous destination.
On an active route, use cursor as via point (intermediate location)
before destination (only available in Advanced mode).
More information
There are distance type values that can be
shown.
● Distance remaining to destination
● Distance remaining to next via point
● Current altitude
Description
More information
A higher number of lit bars indicates better
GPS position accuracy.
Action