Entering Addresses For Repeating House Number Allocation - Eclipse AVN726EA Owner's Manual

7
Touch [<Street Name>].
● Start entering the street name on the
keyboard.
● After entering a couple of characters, the
names that match the string appear in a
list.
● Touch [Done] to open a list of results
before one appears automatically.
8
Select the street from the list.
9
Touch [<House Number>].
● Enter the house number on the keyboard.
Touch [Done] to finish entering the
10
address.
The map appears with the selected
11
point in the middle. From the Cursor
menu, touch [Set as Destination]
(Advanced mode). The route is then
automatically calculated, and you can
start navigating.
91
■ Entering addresses for repeating
house number allocation
On some long roads house numbering is
restarted at some point. Hence, the same
house number can appear twice or even
more times on the same road. If this is the
case, after entering the house number, you
need to select the appropriate address by the
district/suburb information.
Touch the following switches: [Find],
1
[Find Address] (Advanced mode).
By default, Navigation proposes the
2
country/state and city where you are. If
needed, touch the switch with the
name of the country/state, and select a
different one from the list.
3
If needed, change the city.
● To select the city from the list of recently
used ones, touch the
Touch the following switches. After
4
changing the country/state, touch
[<Enter Suburb/Town Name>].
● Start entering the city name on the key
board.
● After entering a couple of characters, the
names that match the string appear in a
list.
● Touch [Done] to open a list of results
before one appears automatically.
5
Pick the city from the list.
switch.
91