Selecting From Postcode - Eclipse AVN726EA Owner's Manual

6
Touch [City Centre].
The map appears with the selected
7
point in the middle. From the Cursor
menu, touch [Set as Destination]
(Advanced mode). The route is then
automatically calculated, and you can
start navigating.

■ Selecting from Postcode

All of the above
possibilities can be performed when entering
the Postcode instead of the city name. The
following is an example for a full address.
Touch the following switches: [Find],
1
[Find Address] (Advanced mode).
By default, Navigation proposes the
2
country/state and city where you are. If
needed, touch the switch with the
name of the country/state, and select a
different one from the list.
Touch the City Name switch, and enter
3
the Postcode.
● Start entering the Postcode on the
keyboard.
● After entering a couple of numbers,
matching city names appear in a list.
● Touch [Done] to open a list of results
before one appears automatically.
95
address searching
4
Pick the city from the list.
5
Touch [<Street Name>].
● Start entering the street name on the
keyboard.
● After entering a couple of characters, the
names that match the string appear in a
list.
● Touch [Done] to open a list of results
before one appears automatically.
6
Select the street from the list.
7
Touch [<House Number>].
● Enter the house number on the keyboard.
Touch [Done] to finish entering the
8
address.
The map appears with the selected
9
point in the middle. From the Cursor
menu, touch [Set as Destination]
(Advanced mode). The route is then
automatically calculated, and you can
start navigating.
95